GENERAL KNOWLEDGE CDL TEST MICHIGAN - PRACTICE TEST

41. HAZMAT placards are:
regulatory signs
warning signs
speed signs
42. When you are driving on a slippery road, you should NOT:
use the engine brake or speed retarder.
keep a longer following distance.
adjust turning and braking to road conditions.
43. What is a pull up when referring to truck driving?
When a driver stops and pulls forward to get a better position.
A specific maneuver used to decelerate smoothly in the exit lane.
A driving maneuver used to pull your vehicle over to the side of the road and stop.
44. If your drive wheels begin to spin, you should:
use the Anti-lock Braking System.
take your foot off the accelerator.
pump the brake pedal three times.
45. When making a turn, you should cancel your turn signal:
once you have completed the turn.
once the rear end of your cab has cleared the turn.
once more than half of your vehicle is round the turn.
46. Before driving a vehicle with a dual brake brake system, the driver should:
allow time for the air compressor to build up a minimum of 100 psi pressure in both the primary and secondary systems.
pump the brake pedal 10 times to build pressure.
wait at least 10 minutes before driving.
47. When checking the condition of the visible parts during your pre-trip inspection, make sure that the _________ are secured against rubbing, snagging or wearing.
tailboards
air lines and electrical wiring
reflectors
48. Gross vehicle weight (GVW) is:
the total weight of a single vehicle, except its load.
the total weight of a single vehicle including its load.
the total weight of the vehicle axle.
49. Hanging meat in a refrigerated truck can be:
a very stable load if properly distributed.
a very unstable load with a low center of gravity.
a very unstable load with a high center of gravity.
50. Driving in very hot weather:
can decrease oil pressure.
can increase tire pressure.
should never be done.
GRADE ME
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More