CDL GENERAL KNOWLEDGE TEST (COLORADO) - PRACTICE TEST

41. The Gross Vehicle Weight Rating (GVWR) is:
the value specified by the manufacturer as the loaded weight of a single vehicle.
the value specified by the manufacturer as the loaded weight of a combination vehicle.
the value specified by the manufacturer as the loaded weight of a vehicle, including cargo and trailers.
the minimum weight that must be hauled by a vehicle, as specified by the manufacturer.
42. The tire load for each tire is stated:
on the vehicle's operator manual.
on the inside of the tire.
on the side of the tire.
on the tread of the tire.
43. The minimum tire tread depth for all tires other than front tires is:
1/32 inch
2/32 inch
6/32 inch
4/32 inch
44. Hydroplaning:
is more likely when tire pressure is low.
only occurs at speeds above 55 mph.
is more likely to occur when tire tread is in good condition.
causes your vehicle to go faster.
45. Mud flaps equipped for the purpose of preventing the slinging of mud and slush must reach to within _____ of the surface of the highway.
8 inches
12 inches
4 inches
24 inches
46. Before driving a vehicle with a dual brake brake system, the driver should:
pump the brake pedal 10 times to build pressure.
wait at least 5 minutes before driving.
allow time for the air compressor to build up a minimum of 100 psi pressure in both the primary and secondary systems.
wait at least 10 minutes before driving.
47. When inspecting your vehicle for suspension system defects, look for:
cracked or broken spring hangers.
leaking shock absorbers.
missing or broken leaves in any leaf spring.
All of the above.
48. When the spring brakes are on, you should:
pump the brakes.
not push the brake pedal down.
exceed the posted speed limit.
press the accelerator.
49. When backing, if you are unsure you should:
turn toward the passenger's side.
call your dispatcher.
continue backing.
get out of your vehicle and check your path.
50. Before driving a vehicle with a dual air system, allow time for the air compressor to build up a minimum of ____ pressure in both the primary and secondary systems.
75 psi
50 psi
100 psi
25 psi
GRADE ME
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More