MT CDL AIR BRAKES PRACTICE TEST
View instructions
The air brakes endorsement applies to applicants who wish to drive a vehicle with air brakes in Class A, B, or C CDL. To drive a vehicle with air brakes, you must pass the air brake component of the Montana CDL knowledge test. The MT CDL air brakes test consists of 25 questions, and you'll need at least 20 correct answers to pass (80%). The test covers the information found in the air brakes section of the Montana CDL Manual. Take this MT CDL practice test now to prepare for the actual air brakes test!
1.
You should drain the air tanks completely. If water and oil collect in the air tanks:
|
your brakes could fail.
|
|
|
your brakes could heat up.
|
|
|
your brakes could become hard to press.
|
|
|
None of the above.
|
2.
The safety relief valve is usually set to open at ____ psi.
|
75
|
|
|
100
|
|
|
50
|
|
|
150
|
3.
If the low air pressure warning light comes on, you should:
|
call for help.
|
|
|
continue to drive normally.
|
|
|
set the parking brake.
|
|
|
stop immediately.
|
4.
The safety valve installed in the first tank the air compressor pumps air is set to open:
|
if there is too little pressure.
|
|
|
every 15 minutes.
|
|
|
if there is too much pressure.
|
|
|
at 30 psi.
|
5.
Dual tires:
|
are dangerous.
|
|
|
should not come in contact with each other.
|
|
|
should always come in contact with each other.
|
|
|
should come in contact with each other whenever possible.
|
Next page
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More