GENERAL KNOWLEDGE CDL TEST TENNESSEE - PRACTICE TEST

11. Before entering a curve, drivers should:
put the transmission in Neutral.
downshift to the right gear.
speed up.
drive on the shoulder.
12. When you are driving on a slippery road, you should NOT:
adjust turning and braking to road conditions.
keep a longer following distance.
use the engine brake or speed retarder.
take curves at slower speeds.
13. Which of the following is true about high beams?
Using them seriously cuts down on your ability to see ahead.
High beams should be used when it is safe and legal to do so.
You should use them when you are not within 50 feet of an approaching vehicle.
They should be used only if low beams suddenly stop working.
14. Which of the following is a common cause of fire?
Short circuits due to loose connections.
Under-inflated tires and duals that touch.
Improperly sealed cargo.
All of the above.
15. The height of the vehicle's center of gravity:
should only be a concern when driving in high winds.
should only be a concern when loading a vehicle.
is very important for safe handling.
should only be a concern when driving a vehicle.
16. Which of the following is NOT checked in a pre-trip inspection?
Cargo securement
Brake controls
Safety equipment
The amount of fuel in the vehicle
17. If a load is 10 feet long, the minimum number of tie-downs required is:
2
1
4
3
18. If you've been drinking alcohol, only ____ will sober you up.
black coffee
time
exercise
a cold shower
19. When you have to back, use a helper whenever possible. Before you begin backing, work out a set of hand signals that you both understand. It is especially important to agree on a signal for:
"Stop"
"Go"
"Move"
"Get closer"
20. Federal, State, and local regulations concerning commercial vehicle weight, securing cargo, and covering loads vary widely. You should obey:
State regulations
Federal regulations
Local regulations
All of the above.
Next page
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More