GENERAL KNOWLEDGE CDL TEST ARIZONA - PRACTICE TEST

41. Before driving a vehicle with a dual brake brake system, the driver should:
wait at least 10 minutes before driving.
pump the brake pedal 10 times to build pressure.
allow time for the air compressor to build up a minimum of 100 psi pressure in both the primary and secondary systems.
42. If your vehicle is hydroplaning, you should:
stay off the brake.
speed up.
put the vehicle in reverse.
43. For fire safety, the correct list of items you should check during your pre-trip inspection is:
fuel and fire extinguisher.
tires, cargo, fuel, electrical and exhaust systems, fire extinguisher.
cargo, fuel, electrical and exhaust systems.
44. You are driving on a steep downgrade in the proper low gear. Your "safe" speed is 40 mph. When your speed reaches 40 mph, you should:
increase your speed to approximately 45 mph, and then apply release the brakes.
apply the brakes to gradually reduce your speed to 35 mph, and then release the brakes.
apply the brakes to quickly reduce your speed to 25 mph, and then release the brakes.
45. If you find anything unsafe during the pre-trip inspection, you are required to:
write it in your inspection report.
get it fixed before driving.
drive cautiously until it is fixed.
46. If you are driving a 30 foot vehicle at 35 mph, you should leave at least _______ between your vehicle and the vehicle in front of you.
4 seconds
2 seconds
3 seconds
47. If you are involved in a collision and not seriously hurt, you should:
protect the area.
do your best to care for the injured.
All of the above.
48. When driving in extremely hot weather, if the air pressure in the tires is too high, you should:
let air out of the tires to decrease pressure.
stop and remain stopped until the tires cool off.
continue driving.
49. To keep your vehicle from rolling back when you start, you should:
turn the engine off before you take your foot off the brake.
partly engage the clutch before you take your foot off the brake.
apply the emergency brake whenever necessary.
50. The safety valve is usually set to open at:
100 psi.
200 psi.
150 psi.
GRADE ME
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More