CDL PASSENGER TEST KANSAS

11. To avoid a hazard:
changing lanes is always the best thing to do.
stopping is always the best thing to do.
driving on the shoulder of the road is always the best thing to do.
steering away from what is ahead may be the best thing to do.
12. Brake fade results from:
using brakes in cold weather.
wet brakes.
excessive heat caused by using brakes too much.
All of the above.
13. If you realize you are going to be later to your destination than you expected, you should:
do your best to avoid the delay.
speed up.
exceed the posted speed limit when no other vehicles are near.
deal with it and accept the delay.
14. The brake and accelerator interlock system (if your bus has one):
should never be used in place of the parking brake.
is used to shut the air off and put on the trailer emergency brakes.
should be used in place of the service brake.
applies the brakes when the rear door is closed.
15. If your vehicle has power steering, during your pre-trip external inspection you must check that:
there are no power steering fluid leaks or damage to the power steering hoses.
the engine rpm is down close to idle.
there are 2 lit red lights indicating it's there.
there's a function light.
16. When loading or unloading passengers, put the transmission:
in first gear.
in reverse.
second gear.
in Neutral.
17. When you double your speed from 20 to 40 mph, the braking distance:
doubles.
increases slightly.
is 4 times longer.
stays about the same.
18. Never refuel your bus:
in a closed building with riders on board.
while the windows are open.
with a higher grade of fuel.
All of the above.
19. If stopped on a hill, how can you start moving without rolling back?
Release the parking brake before you have applied enough engine power to keep from rolling back.
Press on the gas pedal, even if you have to roll back a little.
Partly engage the clutch before you take your right foot off the brake, put on the parking brake if necessary.
None of the above.
20. Before driving a vehicle with a dual air system, the air compressor should build up a minimum of _____ pressure in both the primary and secondary systems.
100 psi
75 psi
50 psi
10 psi
GRADE ME
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More