UT CDL Practice Test - General Knowledge

31. If another driver is following you too closely, you should:
turn on your warning flashers.
immediately pull over to the side of the road.
decrease your following distance.
None of the above.
32. You are driving a heavy vehicle with a manual transmission, and you have to stop on the shoulder while driving on an uphill grade. When putting your vehicle back in motion up the grade, you should:
shift down to a speed that you can control without using the brakes.
keep the clutch slipping while slowly accelerating.
partly engage the clutch before you take your right foot off the brake.
use the parking brake to hold the vehicle until the clutch engages.
33. Vehicle inspections:
are not required for trips under 50 miles.
are required once a month.
should only be performed by a certified mechanic.
are required by state and federal law.
34. If your trailer starts to skid, you should:
pump the brakes.
steer in the opposite direction.
lock the brakes.
release the brakes.
35. To test the service brake:
gently try to pull forward with the trailer parking brake on, then release the brake.
push the brake pedal firmly while slowly moving backward.
shift your transmission to a low gear, pump the brake pedal three times, then hold it down for five seconds.
push the brake pedal firmly while going about 5 mph.
36. Hanging meat in a refrigerated truck:
can be a very unstable load.
creates a low center of gravity.
should never be transported.
will not affect safe driving ability.
37. When the road is very slippery, you should:
stop at the first safe place.
downshift to stop.
use the parking brake instead of the service brake.
apply the brakes often to keep the linings dry.
38. Which of the following is not a braking system on a truck?
Steering brake
Service brake
Emergency brake
Parking brake
39. When driving on wet roads, you should:
reduce speed by 60%.
follow the vehicle ahead more closely than under ideal driving conditions.
reduce speed by about one-third.
pull of the road and get some rest.
40. A passive railroad crossing is one that:
requires you to stop and wait until the traffic control device installed at the crossing tells you to proceed.
has at least two traffic control devices installed at the crossing to regulate traffic.
has a traffic control device installed at the crossing to regulate traffic.
does not have any type of traffic control device.
Next page
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More