MN DMV MOTORCYCLE LICENSE TEST

11. When a driver on an entrance ramp is merging into your lane, you should:
increase your speed.
sound your horn.
change to another lane if one is open.
slow down.
12. You should operate the engine cut-off switch and pull in the clutch when:
you start to lose control in a curve.
the motorcycle starts to wobble.
the throttle is stuck and you cannot free it.
a tire goes flat.
13. The best way to prevent and overcome fatigue while riding is to:
drink coffee at least every two hours.
take frequent rest breaks.
avoid using windshields.
get used to riding more than eight hours a day.
14. Your passenger should tighten his or her hold when you:
are about to start from a stop.
approach surface hazards.
All the other answers are correct.
are about to turn sharply.
15. If you encounter a large surface so slippery that you must coast:
gradually increase your speed.
sit as far back as possible.
consider letting your feet skim along the surface.
warn other drivers that you will make a sudden move.
16. Surfaces that provide poor traction include:
All the other answers are correct.
Snow
Mud
Gravel roads
17. What is the best lane position for being seen?
The center of the lane
The left portion of the lane
It depends on the situation
The right portion of the lane
18. The best lane position to ride in is:
the left lane position.
the center lane position.
the right lane position.
the one where you are most likely to be seen.
19. The best way to stop quickly is to:
use the rear brake only.
use the front brake only.
apply the rear brake, then the front brake.
use both the front and rear brakes at the same time.
20. If your motorcycle starts to wander back and forth while riding over metal bridge gratings you should:
relax, stay on course, and ride straight across.
proceed in a zigzag pattern until you cross the bridge.
downshift to a lower gear to improve stability.
ride is in the center lane position.
Next page
NOT SURE YOU WILL PASS? GET MOTORCYCLE PREMIUM NOW! - Learn More