View instructions
To obtain a CDL, you will be required to pass a vehicle inspection test. The vehicle inspection test, formerly known as pre-trip, is a skills test to see if you identify which features and equipment on the test vehicle should be inspected before driving. During the test, you will be asked to do an inspection of your vehicle. You will be expected to show your knowledge of the inspection process and you will be tested to see if you know whether your vehicle is safe to drive. During the CDL inspection test, DMV does not allow the use of testing aids, other than the vehicle inspection guide in the Ohio CDL Manual. To prepare for the test, study the following sections of the CDL manual: Driving Safely and the Vehicle Inspection Test. If you do not pass the CDL inspection test, the other skills tests will be postponed.
1.
During the pre-trip inspection, when starting the engine you should:
check the coolant level in the radiator.
|
|
fasten your safety belt.
|
|
listen for unusual noises.
|
2.
You should check that the _____ is solid, clear of objects, and securely bolted to the tractor frame.
sliding pintle
|
|
catwalk
|
|
apron
|
3.
What should you do to test your hydraulic brakes for leaks?
Hold the brake pedal down for five seconds, then pump it three times.
|
|
Pump the brake pedal five times, then apply pressure for three seconds.
|
|
Pump the brake pedal three times, then apply pressure to the pedal and hold for five seconds.
|
4.
You are checking the tractor-trailer connection to make sure it is safe and secure. The landing gear should be:
fully lowered.
|
|
raised slightly off the ground.
|
|
fully raised.
|
5.
Which of the following is NOT true? During the vehicle inspection test, when starting the engine you should show that:
the temperature gauge is working.
|
|
the oil pressure gauge is working.
|
|
the oil pressure gauge comes on when braking.
|
6.
When approaching a vehicle as part of a pre-trip inspection, the driver should look under the vehicle for all of the following except:
Windshield wiper fluid
|
|
Coolant
|
|
Grease
|
7.
Pre-trip inspections:
should not be done when a vehicle inspection report is available.
|
|
should not be done unless the vehicle has problems that could cause a breakdown.
|
|
should always be done in the same order.
|
8.
The "Start Engine and Inspect inside of the Cab" step of the 7-step inspection method involves each of the following, EXCEPT:
checking the air pressure gauge.
|
|
check the condition of the controls.
|
|
checking engine oil level.
|
9.
During the vehicle inspection test, you will be asked to:
explain to the examiner what you would inspect and why.
|
|
move your vehicle forward, backward.
|
|
change the coolant.
|
10.
If you find anything unsafe during the pre-trip inspection, you are required to:
drive cautiously until it is fixed.
|
|
write it in your inspection report.
|
|
get it fixed before driving.
|
Page 1 of 2
Next page
Grade this page