View instructions
To obtain a CDL, you will be required to pass a vehicle inspection test. The vehicle inspection test, formerly known as pre-trip, is a skills test to see if you identify which features and equipment on the test vehicle should be inspected before driving. During the test, you will be asked to do an inspection of your vehicle. You will be expected to show your knowledge of the inspection process and you will be tested to see if you know whether your vehicle is safe to drive. During the CDL inspection test, DMV does not allow the use of testing aids, other than the vehicle inspection guide in the Michigan CDL Manual. To prepare for the test, study the following sections of the CDL manual: Driving Safely and the Vehicle Inspection Test. If you do not pass the CDL inspection test, the other skills tests will be postponed.
1.
During the vehicle inspection test, when asked to check the power steering fluid you should:
|
check for adequate power steering fluid level.
|
|
|
indicate where power steering fluid dipstick is located.
|
|
|
All of the above.
|
2.
You should check that the _____ is solid, clear of objects, and securely bolted to the tractor frame.
|
catwalk
|
|
|
apron
|
|
|
sliding pintle
|
3.
Which of the following is NOT checked in a pre-trip inspection?
|
The amount of fuel in the vehicle
|
|
|
Cargo securement
|
|
|
Safety equipment
|
4.
When taking the road test, if asked to make a turn you should:
|
only use the turn signal if other vehicles are present.
|
|
|
gradually increase your speed.
|
|
|
check traffic in all directions.
|
5.
When approaching a vehicle for a pre-trip inspection, you should:
|
look under the vehicle for fuel leaks, fresh oil, coolant or grease.
|
|
|
make sure the parking brake is on.
|
|
|
look under the vehicle for hazards to vehicle movement.
|
6.
If you find anything unsafe during the pre-trip inspection, you are required to:
|
get it fixed before driving.
|
|
|
write it in your inspection report.
|
|
|
drive cautiously until it is fixed.
|
7.
Brake drums (or discs) must not have cracks longer than:
|
the width of the friction area.
|
|
|
one half the width of the friction area.
|
|
|
twice the width of the friction area.
|
8.
All CDL vehicle inspection tests include:
|
an engine start and in-cab inspection.
|
|
|
an engine start and an inspection of the entire vehicle.
|
|
|
an engine inspection and tire check.
|
9.
During the vehicle inspection, you will be expected to do all of the following except:
|
show that the vehicle is safe to drive.
|
|
|
touch and name the item you are inspecting and explain why.
|
|
|
change a tire.
|
10.
If you are checking that the air hoses and electrical lines are not spliced, cut, chafed or worn, you are inspecting:
|
the exhaust system.
|
|
|
the mounting bolts.
|
|
|
the air / electric lines.
|
Page 1 of 2
Next page
Grade this page