CDL VEHICLE INSPECTION TEST MONTANA

11. If loose or missing, _______ may cause movement between the frame and fifth wheel assembly.
safety chains
locking pins
electric connectors
mounting bolts
12. Signs of bad brake drums or shoes include the following except:
Cracked drums
Shoes with brake fluid on them
Shoes with no oil on them
Shoes worn thin
13. When performing the stop/start maneuver during the skills test, you should:
not use your turn signals.
apply the brakes as hard as you can without locking the wheels.
decelerate smoothly.
activate your left turn signal.
14. Pre-trip inspections are:
required only for trips of more than 100 miles.
required by law
required only for trips of more than 50 miles.
recommended.
15. During the vehicle inspection, you should check your clutch for:
Sticking
Looseness
Damage
All of the above.
16. You are checking the tractor-trailer connection to make sure it is safe and secure. The landing gear should be:
fully lowered.
fully raised.
raised slightly off the ground.
None of the above.
17. During the pre-trip inspection, when starting the engine you should:
check the coolant level in the radiator.
fasten your safety belt.
listen for unusual noises.
press the brake pedal.
18. All CDL vehicle inspection tests include:
an in-cab inspection and background check.
an engine start and an inspection of the entire vehicle.
an engine inspection and tire check.
an engine start and in-cab inspection.
19. You pump the brake pedal three times, then hold it down for five seconds, making sure that the pedal does not move. You are checking:
the service brake.
the hydraulic brakes.
the air brakes.
the parking brake.
20. Brake drums (or discs) must not have cracks longer than:
the width of the friction area.
one third the width of the friction area.
twice the width of the friction area.
one half the width of the friction area.
GRADE ME
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More