In Partnership with William K. Kohrs Memorial Library

View instructions
To obtain a CDL, you will be required to pass a vehicle inspection test. The vehicle inspection test, formerly known as pre-trip, is a skills test to see if you identify which features and equipment on the test vehicle should be inspected before driving. During the test, you will be asked to do an inspection of your vehicle. You will be expected to show your knowledge of the inspection process and you will be tested to see if you know whether your vehicle is safe to drive. During the CDL inspection test, DMV does not allow the use of testing aids, other than the vehicle inspection guide in the Montana CDL Manual. To prepare for the test, study the following sections of the CDL manual: Driving Safely and the Vehicle Inspection Test. If you do not pass the CDL inspection test, the other skills tests will be postponed.
1. Checking the automatic transmission fluid level may require:
the 4-way emergency flashers to be activated.
the engine to be running.
you to pump the brake.
the vehicle to be parked downhill.
2. The "Start Engine and Inspect inside of the Cab" step of the 7-step inspection method involves each of the following, EXCEPT:
check the condition of the controls.
starting the engine, then listening for unusual noises.
checking engine oil level.
checking the air pressure gauge.
3. When checking the engine compartment:
the parking brake should be on.
wheels should not be chocked.
the engine should be running.
you should put the gearshift in neutral.
4. During the skills test, if you must stop before making the turn, you should:
let your vehicle roll.
come to a complete stop after the line to get a better view.
make sure the turn signal is off.
keep the front wheel aimed straight ahead.
5. Which of the following is NOT a key part of the steering system?
Drag link
Tie rod
Steering shaft
Axle
6. During a pre-trip inspection, to check your lights you should:
with the engine running, turn on the headlights and 4-way emergency flashers, and get out of the vehicle.
with the engine running, put the vehicle in a forward gear and turn on the headlights.
turn off the engine, turn on the headlights and 4-way emergency flashers, and get out of the vehicle.
check the yellow malfunction lamps on the instrument panel.
7. When starting your vehicle, oil pressure should come up to normal:
within seconds.
in about a minute.
in about two minutes.
within 5 minutes of driving.
8. When taking the road test, if asked to make a turn you should:
use turn signals.
slow down before making the turn.
check for traffic in all directions.
All of the above.
9. When taking the road test, if asked to make a turn you should:
only use the turn signal if other vehicles are present.
check traffic in all directions.
gradually increase your speed.
All of the above.
10. During your inspection, you should look into the fifth-wheel gap and check that the _________ are fully closed around the kingpin.
lug nuts
couplings (U-joints)
mounting bolts
locking jaws
 
Page 1 of 2
Next page

Inspection Test - MT CDL

Number of questions: 20
Correct answers to pass:16
Passing score:80%
Share This Online CDL Test
Rate this Inspection Test -CDL
4.9 out of 5
based on 322 votes