TN CDL VEHICLE INSPECTION TEST
11.
During the vehicle inspection test, you will be asked to:
|
change the coolant.
|
|
|
change a tire.
|
|
|
explain to the examiner what you would inspect and why.
|
|
|
move your vehicle forward, backward.
|
12.
When taking the road test, you will be evaluated on your gear usage. You should do all of the following except:
|
select a gear that does not lug the engine.
|
|
|
not grind the gears.
|
|
|
select a gear that does not rev the engine.
|
|
|
shift in turns and intersections.
|
13.
During the driving test, when approaching a railroad crossing, you should _________ while your vehicle is in the crossing.
|
change lanes
|
|
|
not change gears
|
|
|
pass slow moving vehicles
|
|
|
None of the above.
|
14.
During the vehicle inspection, when asked to check the oil level you should:
|
make sure the engine is off.
|
|
|
see that the oil level is within safe operating range.
|
|
|
indicate where the dipstick is located.
|
|
|
All of the above.
|
15.
Doing a vehicle inspection is very important. Why?
|
A defect found during an inspection could save you problems later.
|
|
|
Federal and state regulations require that drivers inspect their vehicle.
|
|
|
Not doing it could cost time and dollars, or even worse, an accident.
|
|
|
All of the above.
|
16.
During the vehicle inspection, make sure that the _____ is in the engaged position and that the safety latch is in place.
|
drawbar
|
|
|
locking jaw
|
|
|
apron
|
|
|
release arm
|
17.
What is a pull up when referring to truck driving?
|
When a driver stops and pulls forward to get a better position.
|
|
|
Using the speedometer to know when to shift up.
|
|
|
A driving maneuver used to pull your vehicle over to the side of the road and stop.
|
|
|
A specific maneuver used to decelerate smoothly in the exit lane.
|
18.
When entering traffic on an expressway during the skills test, you should:
|
avoid using turn signals.
|
|
|
cut other drivers off if needed.
|
|
|
slow down to a crawl.
|
|
|
check for traffic.
|
19.
When taking the road test, if asked to make a turn you should:
|
gradually increase your speed.
|
|
|
only use the turn signal if other vehicles are present.
|
|
|
check traffic in all directions.
|
|
|
All of the above.
|
20.
Rust around wheel nuts may mean:
|
the wheels or rims have had welding repairs.
|
|
|
the nuts are too tight.
|
|
|
the nuts are loose.
|
|
|
the weather is wet.
|
GRADE ME
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More