CDL VEHICLE INSPECTION TEST TEXAS

11. Suspension system defects include:
cracked or broken spring hangers.
rust around wheel nuts.
steering wheel play of more than 10 degrees.
All of the above.
12. Which of the following is NOT a tire problem to look for during the vehicle inspection?
Radial and bias-ply tires used together
Cracked valve stems
Recapped tires on the front of a school bus
All the tires are made by the same manufacturer
13. During the vehicle inspection test, you may be asked to:
change the coolant.
remove a spare electrical fuse.
check the engine oil level.
replace the electrical and brake lines.
14. Which of the following is checked in a pre-trip inspection?
Steering wheel
Wiper blades
Mirrors and windshield
All of the above.
15. Suspension system defects may include all of the following except:
Missing or broken leaf springs
Distorted coil springs
Cracked spring hangers
Cracked hoses
16. You are checking the tractor-trailer connection to make sure it is safe and secure. The landing gear should be:
fully lowered.
fully raised.
raised slightly off the ground.
None of the above.
17. During a pre-trip inspection, when checking the power steering hoses, you should:
look for broken or distorted coil springs.
check for leaks.
check that the brake chambers are not leaking.
check for damaged or bent rims.
18. Which of the following engages and disengages the engine from the drive train?
The clutch
The drive shaft
The foot brake
The front axle
19. When performing the stop/start maneuver during the skills test, you should:
activate your left turn signal.
not use your turn signals.
apply the brakes as hard as you can without locking the wheels.
decelerate smoothly.
20. When checking tires, which of the following is not a problem?
Too much air pressure
4/32 inch tread depth on front tires
Cracked valve stems
Radial and bias-ply tires used together
GRADE ME
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More