CDL HAZMAT PRACTICE TEST UTAH

11. After starting the engine the coolant temperature should:
rise quickly.
rise gradually.
hold steady.
slowly decrease.
12. What is a safe haven?
The storage container tank where hazardous materials must be stored.
The place where commercial drivers convicted for DUI must attend a one-week special driver education course.
A place where hazardous materials can be safely dumped.
An approved place for parking unattended vehicles loaded with explosives.
13. After starting the engine, the ABS light stays on. This means:
the ABS is in Neutral.
the ABS is working properly.
the ABS is not working properly.
the ABS oil level is not adequate.
14. Which of the following is true? If a HazMat is a Poison Inhalation Hazard:
a POISON INHALATION HAZARD placard must be used in addition to other placards.
a POISON INHALATION HAZARD placard must always be displayed even for small amounts.
the material will have special requirements for shipping papers.
All of the above.
15. Two of the most common causes of tire fires are:
Duals that touch and under-inflated tires.
Over-inflated tires and duals that touch.
Driver smoking and bleeding tar.
Loose lug nuts and duals that touch.
16. When driving, you should check mirrors regularly to know where other vehicles are around you. Remember that:
convex mirrors make things look larger and closer than they really are.
there are blind spots that your mirrors cannot show you.
you should check your after the start of any trip to make sure they are properly adjusted.
every registered motor vehicle must have at least one mirror.
17. What is the most important reason to inspect your vehicle?
Saving money by preventing costly repairs.
Achieving the best gas mileage.
Vehicle inspection is required by federal and state laws.
Your safety and that of other road users.
18. To avoid a hazard:
steering away from what is ahead may be the best thing to do.
driving on the shoulder of the road is always the best thing to do.
stopping is always the best thing to do.
changing lanes is always the best thing to do.
19. Highway curves should be taken _________ the posted speed limit.
slightly below
at
slightly above
well below
20. When moving Division 1.1 or 1.2 materials, the floor liner you use must be:
either non-metallic material or non-ferrous metal.
ferrous metal.
metallic.
None of the above.
Next page
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More