View instructions
To obtain a CDL, you will be required to pass a vehicle inspection test. The vehicle inspection test, formerly known as pre-trip, is a skills test to see if you identify which features and equipment on the test vehicle should be inspected before driving. During the test, you will be asked to do an inspection of your vehicle. You will be expected to show your knowledge of the inspection process and you will be tested to see if you know whether your vehicle is safe to drive. During the CDL inspection test, DMV does not allow the use of testing aids, other than the vehicle inspection guide in the Wisconsin CDL Manual. To prepare for the test, study the following sections of the CDL manual: Driving Safely and the Vehicle Inspection Test. If you do not pass the CDL inspection test, the other skills tests will be postponed.
1.
Pre-trip inspections of doubles and triples should:
|
take less time than inspecting straight trucks.
|
|
|
be done once a week.
|
|
|
be done by the shipper.
|
|
|
take more time than inspecting straight trucks.
|
2.
During the vehicle inspection, when approaching the vehicle you should:
|
check that the parking brakes are not set.
|
|
|
check that the vehicle is parked properly.
|
|
|
look under the vehicle for fresh oil, fuel leaks or coolant.
|
|
|
check that the vehicle is clear.
|
3.
When taking the road test, you will be expected to make regular traffic checks. You should do all of the following except:
|
checking engine oil level.
|
|
|
checking for traffic regularly.
|
|
|
checking mirrors regularly.
|
|
|
check your mirrors for traffic after an intersection.
|
4.
As part of your pre-trip inspection, make sure:
|
your cargo does not obscure your view.
|
|
|
the cargo is balanced properly.
|
|
|
the vehicle is not overloaded.
|
|
|
All of the above.
|
5.
When taking the road test, you will be evaluated on your lane usage. You should NOT:
|
finish a right turn in the right-most lane.
|
|
|
drive the vehicle over curbs.
|
|
|
stop behind crosswalks.
|
|
|
complete a turn in the proper lane on a multiple lane road.
|
6.
Which of the following is NOT part of a standard vehicle inspection?
|
Seating defects.
|
|
|
Wheel and rim problems.
|
|
|
Bad brake drums or shoes.
|
|
|
Tire problems.
|
7.
When checking tires, which of the following is acceptable?
|
Dual tires that come in contact with each other
|
|
|
Dual tires that do not come in contact with each other
|
|
|
Radial and bias-ply tires used together.
|
|
|
Retreaded tires on the front wheels of a bus
|
8.
During the vehicle inspection, when asked to check the oil level you should:
|
make sure the engine is off.
|
|
|
see that the oil level is within safe operating range.
|
|
|
indicate where the dipstick is located.
|
|
|
All of the above.
|
9.
Exhaust system parts should NOT:
|
rub against tires.
|
|
|
rub against fuel system parts.
|
|
|
be loose.
|
|
|
All of the above.
|
10.
During the external inspection, you should check that the _______ (if equipped) are evenly centered, with the dual wheels and tires evenly separated, and are not bent, damaged, or rusted through.
|
axle seals
|
|
|
spacers
|
|
|
lug nuts
|
|
|
All of the above.
|
Page 1 of 2
Next page
Grade this page