Save Time and Get a Pass Guarantee! LIMITED-TIME OFFER: Get CDL PREMIUM Now and SAVE $64! Upgrade To Premium

VEHICLE INSPECTION CDL TEST WYOMING

View instructions
To obtain a CDL, you will be required to pass a vehicle inspection test. The vehicle inspection test, formerly known as pre-trip, is a skills test to see if you identify which features and equipment on the test vehicle should be inspected before driving. During the test, you will be asked to do an inspection of your vehicle. You will be expected to show your knowledge of the inspection process and you will be tested to see if you know whether your vehicle is safe to drive. During the CDL inspection test, DMV does not allow the use of testing aids, other than the vehicle inspection guide in the Wyoming CDL Manual. To prepare for the test, study the following sections of the CDL manual: Driving Safely and the Vehicle Inspection Test. If you do not pass the CDL inspection test, the other skills tests will be postponed.
1. When taking the road test, if asked to make a turn you should:
slow down before making the turn.
use turn signals.
check for traffic in all directions.
All of the above.
2. You are checking the dipstick to see that the oil level is within the safe operating range. The level must be:
below the power steering fluid level.
above the coolant level.
below the refill mark.
above the refill mark.
3. During the pre-trip vehicle inspection test, when examining hoses with the examiner, look for:
puddles on the ground.
the temperature gauge.
spare electrical fuses.
frays in the water pump belt.
4. Pre-trip inspections:
should not be done when a vehicle inspection report is available.
should not be done unless the vehicle has problems that could cause a breakdown.
are optional when the driver is familiar with the vehicle.
should always be done in the same order.
5. During the vehicle inspection, you will be expected to do all of the following except:
show that the vehicle is safe to drive.
walk around the vehicle.
change a tire.
touch and name the item you are inspecting and explain why.
6. Exhaust system parts should be:
rubbing against fuel system parts.
loose.
leaking.
None of the above.
7. During the basic control skills test, what is the maximum number of times you may look to check the position of your vehicle in the the straight-line backing exercise?
2
4
3
1
8. In the steering box part of the vehicle inspection test, you should:
check that the steering box is not leaking.
look for any missing nuts or bolts.
check that the steering box is securely mounted.
All of the above.
9. During the vehicle inspection, when asked to check the oil level you should:
see that the oil level is within safe operating range.
indicate where the dipstick is located.
make sure the engine is off.
All of the above.
10. During the vehicle inspection test, after checking the area around the vehicle for hazards, and before opening the engine compartment door, you should:
remove the battery.
depress the clutch.
check the level of brake fluid in the reservoir.
check that the parking brakes are set and/or the wheels are chocked.
 
Page 1 of 2
Next page  
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More
Rate This Free Test
5 out of 5
based on 150 votes

Inspection Test - WY CDL

Number of questions: 20
Correct answers to pass:16
Passing score:80%
Number of questions: 20
Correct answers to pass:16
Passing score:80%
Share This Online CDL Test