OK CDL VEHICLE INSPECTION TEST

11. During the vehicle inspection, when approaching the vehicle you should:
check that the vehicle is clear.
check that the parking brakes are not set.
look under the vehicle for fresh oil, fuel leaks or coolant.
12. Which of the following is NOT part of a standard vehicle inspection?
Bad brake drums or shoes.
Tire problems.
Seating defects.
13. When taking the road test, you will be evaluated on your gear usage. You should do all of the following except:
shift in turns and intersections.
select a gear that does not lug the engine.
not grind the gears.
14. You pump the brake pedal three times, then hold it down for five seconds, making sure that the pedal does not move. You are checking:
the service brake.
the hydraulic brakes.
the air brakes.
15. ______ must have a minimum tread depth of 4/32 of an inch.
Steering axle tires
All tires other than front tires
All of the above.
16. When taking the road test, if asked to make a turn you should:
only use the turn signal if other vehicles are present.
gradually increase your speed.
check traffic in all directions.
17. During the pre-trip inspection test, you will be expected to:
pass three basic control tests.
show that you can identify the bus operating systems, and that you know how to inspect them for safety.
watch the examiner inspect the bus for safety.
18. You are checking the dipstick to see that the oil level is within the safe operating range. The level must be:
below the refill mark.
above the coolant level.
above the refill mark.
19. When checking the lights before driving:
you should turn off the engine.
you should check them from inside the vehicle.
make sure the parking brake is not set.
20. During the vehicle inspection test, when asked to check the power steering fluid you should:
indicate where power steering fluid dipstick is located.
check for adequate power steering fluid level.
All of the above.
GRADE ME
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More