VEHICLE INSPECTION CDL TEST UTAH

11. During the pre-trip inspection, check that the ________  supply air or hydraulic fluid to the brakes.
slack adjusters
brake chambers
brake hoses or lines
brake linings
12. The "Start Engine and Inspect inside of the Cab" step of the 7-step inspection method involves each of the following, EXCEPT:
starting the engine, then listening for unusual noises.
checking the air pressure gauge.
check the condition of the controls.
checking engine oil level.
13. When taking the road test, you will be evaluated on your lane usage. You should NOT:
drive the vehicle over curbs.
stop behind crosswalks.
finish a right turn in the right-most lane.
complete a turn in the proper lane on a multiple lane road.
14. When checking the steering system for defects, you should look for:
loose, broken, or missing tailpipes.
missing or broken leaves in any leaf spring.
cut or cracked valve stems.
bent, loose, or broken parts, such as tie rods.
15. When checking tires, which of the following is not a problem?
Radial and bias-ply tires used together
Too much air pressure
Cracked valve stems
4/32 inch tread depth on front tires
16. Broken suspension parts can be very dangerous. When inspecting your vehicle for suspension system defects, look for:
Damaged air suspension systems.
Spring hangers that allow movement of axle from proper position.
Broken leaves in a multi-leaf spring.
All of the above.
17. During the vehicle inspection test, after checking the area around the vehicle for hazards, and before opening the engine compartment door, you should:
check that the parking brakes are set and/or the wheels are chocked.
check the level of brake fluid in the reservoir.
depress the clutch.
remove the battery.
18. Pre-trip inspections are:
required only for trips of more than 100 miles.
required by law
recommended.
required only for trips of more than 50 miles.
19. How can you tell if your vehicle is equipped with ABS?
Look for yellow ABS malfunction lamps on the instrument panel.
Trailers will have yellow ABS malfunction lamps on the left side.
Look under the vehicle for the wheel speed sensor wires coming from the back of the brakes.
All of the above.
20. Vehicle inspections:
should be performed once a week.
should only be done when a vehicle defect is found.
are important because vehicle defects found during an inspection could save you problems later.
should not be done by the shipper.
GRADE ME
NOT SURE YOU WILL PASS? GET CDL PREMIUM NOW! - Learn More